Parking Sensor Off Switch Inspection
NOTE:
- The parking sensor OFF switch is integrated with the cluster switch No. 1.
- For the parking sensor OFF switch removal/installation, refer to CLUSTER SWITCH REMOVAL/INSTALLATION. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
- Disconnect the cluster switch No. 1 connector. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
- Attach the tester lead to the cluster switch No. 1 wiring harness-side connector and inspect voltage or continuity according to the Terminal Voltage Table (Reference) on the table.
- If not as specified, repair or replace the related wiring harness.
- If as specified, replace the cluster switch No. 1. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
Terminal Voltage Table (Reference)
-: Not applicable
| Terminal | Connected to | Test item | Test condition | Specification | Inspection item(s) |
|---|---|---|---|---|---|
| A | Instrument cluster | Continuity | Cluster switch No. 1 terminal A- Instrument cluster B | Continuity |
|
| B | IG1 relay No. 2 | Voltage | Ignition is switched ON | B+ |
|
| Except above | 1.0 V or less | ||||
| C | Instrument cluster | Continuity | Cluster switch No. 1 terminal C- Instrument cluster AI | Continuity |
|
| D | Ground point | Continuity | Under any condition | Continuity |
|