LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2020 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (VIN M)) >> Engine Oil Data Reset >> Engine Oil Data Reset Procedure

Engine Oil Data Reset Procedure

WARNING: This page is about a different variant/trim than selected.
Step Inspection Results Action Note
1
  • Using the M-MDS, verify the engine oil maintenance monitor function ON/OFF condition.
  • Is the engine oil maintenance monitor function on?
 Yes Go to the next step. If the engine oil maintenance monitor function is on, it is necessary to perform the engine oil data reset.
No The engine oil data reset is unnecessary.
2
  • Switch the ignition OFF (LOCK).
  • Press and hold the tripmeter switch with the ignition switched off, then switch the ignition ON (engine off).
    • Keep pressing the tripmeter switch for more than 5 s.
  • Does the master warning light flash for a few seconds?
 Yes Engine oil data reset is completed. The master warning light flashes for a few seconds when the engine oil data reset procedure is completed.
No Perform Step 2 again.
scientia non olet · About LEMON Manuals