Active Driving Display Short-Cord Removal/Installation

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the battery. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.5T] .) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)] .) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITHOUT CYLINDER DEACTIVATION)] .)
Disconnect the brake pipes from the master cylinder. (See MASTER CYLINDER REMOVAL/INSTALLATION .)
Disconnect the clutch reserve hose from the master cylinder. (MTX) (See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [C66M-R] .)
Remove the following parts:
1. Side wall (driver side) (See SIDE WALL REMOVAL/INSTALLATION .)
2. Front heat duct (LH) (See FRONT HEAT DUCT REMOVAL/INSTALLATION .)
3. Brake pedal (See BRAKE PEDAL REMOVAL/INSTALLATION .)
4. Clutch pedal (MTX) (See CLUTCH PEDAL REMOVAL/INSTALLATION [C66M-R] .)
5. Meter hood No. 2 (See METER HOOD REMOVAL/INSTALLATION .)
6. Active driving display (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION .)
Disconnect the connector.

Fig 1: Active Driving Display And Connector
Courtesy of MAZDA MOTORS CORP.
Remove the clips.

Fig 2: Active Driving Display And Clips
Courtesy of MAZDA MOTORS CORP.
Pull out the active driving display short-cord from the hooks.

Fig 3: Active Driving Display, Active Driving Display Short-Cord And Hook
Courtesy of MAZDA MOTORS CORP.
Remove the active driving display short-cord.
Install in the reverse order of removal.