LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2019 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Mechanical System (VIN Y)) >> Timing Chain Removal/Installation >> Engine Front Cover Removal Note

Engine Front Cover Removal Note

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bolts shown in the figure below and set the wiring harness bracket aside.
    Fig 1: Wiring Harness Bracket, Bolts And Engine Front Cover
    G11436818Courtesy of MAZDA MOTORS CORP.
  2. Remove the engine front cover installation bolts.
  3. Using a screwdriver wrapped in a cloth, peel the sealant away a little at a time, and remove the engine front cover.
CAUTION:
  • Do not apply excessive force to the screwdriver. Otherwise, the engine front cover could be damaged.
  • Be careful not to scratch or damage the seal surface. Otherwise, it could cause oil leakage.
Fig 2: Engine Front Cover Using Screwdriver (1 Of 2)
G11436819Courtesy of MAZDA MOTORS CORP.
Fig 3: Engine Front Cover Using Screwdriver (2 Of 2)
G11436820Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals