Diagnostic Procedure
DTC U3003:04 BLIND SPOT MONITORING (BSM) CONTROL MODULE DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA)
|
Yes | Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) |
| No | Go to Step 3. | ||
| 2 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the blind spot monitoring (BSM) control module, then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (BLIND SPOT MONITORING (BSM) CONTROL MODULE) .) |
| No | DTC troubleshooting completed. | ||