Diagnostic Procedure
DTC U0513:68 BLIND SPOT MONITORING (BSM) CONTROL MODULE DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY DSC HU/CM DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)] .) |
| No | Go to the next step. | ||
| 2 | VERIFY IF MALFUNCTIONING LOCATION IS DSC HU/CM DEPENDING ON REPEATABILITY
|
Yes | Replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .) |
| No | Go to Step 4. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the blind spot monitoring (BSM) control module, then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (BLIND SPOT MONITORING (BSM) CONTROL MODULE) .) |
| No | DTC troubleshooting completed. | ||