LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2019 >> 6 Signature >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag System (Service Information) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures (Two-Step Deployment Control System - Us/CANADA Spec.) >> Deployment Procedure For Outside Of Vehicle >> Notes

Deployment Procedure For Outside Of Vehicle: Notes

  1. Inspect the SST (Deployment tool). (See INSPECTION OF SST (DEPLOYMENT TOOL) (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.) .)
  2. Switch the ignition off.
  3. Disconnect the negative battery terminal and wait for 1 min or more. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  4. Follow the procedure below for operating (deploying) the applicable air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt.
    NOTE:
    • The connector part of the air bag module and the SST (adapter wiring harness) burns out from the high heat when the inflator is operated (deployed).
scientia non olet · About LEMON Manuals