Diagnostic Procedure

DTC B10A6:64 (FRONT BODY CONTROL MODULE (FBCM)) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY FRONT BODY CONTROL MODULE (FBCM) DTCs AGAIN Clear the DTC for the front body control module (FBCM) using the M-MDS. (See CLEARING DTC (FRONT BODY CONTROL MODULE (FBCM)) .) Switch the ignition ON (engine off or on) and wait for 5 s or more. Retrieve the front body control module (FBCM) DTCs using the M-MDS. (See DTC INSPECTION (FRONT BODY CONTROL MODULE (FBCM)) .) Is the same Pending DTC present?	Yes	Go to the next step.
1		No	Go to Step 4.
2	INSPECT LIGHT SWITCH Inspect the light switch. (See LIGHT SWITCH INSPECTION .) Is the light switch normal?	Yes	Replace the start stop unit, then go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the front body control module (FBCM) using the M-MDS. (See CLEARING DTC (FRONT BODY CONTROL MODULE (FBCM)) .) Switch the ignition ON (engine off or on) and wait for 5 s or more. Retrieve the front body control module (FBCM) DTCs using the M-MDS. (See DTC INSPECTION (FRONT BODY CONTROL MODULE (FBCM)) .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the front body control module (FBCM). (See FRONT BODY CONTROL MODULE (FBCM) REMOVAL/INSTALLATION .) Go to the next step.
3		No	Go to the next step.
4	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (FRONT BODY CONTROL MODULE (FBCM)) .)
4		No	DTC troubleshooting completed.