| 1 |
VERIFY THAT REMOTE TRANSMITTER WHICH CAN START ENGINE IS REMOTE TRANSMITTER 1
- Switch the ignition ON (engine off) using remote transmitter 1.
- Verify that the security light illuminates for approx. 3 s, and then turns off.
- Switch the ignition off.
|
Go to the next step. |
| 2 |
PERFORM ADDITIONAL PROGRAMMING OF REMOTE TRANSMITTER 2
- Connect the M-MDS (IDS) to DLC-2. (See M-MDS CONNECTING PROCEDURE .)
- Switch the ignition ON (engine off) using remote transmitter 1.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- "Body"
- "Security"
- "PATS Functions"
- Then, select the following from the screen menu.
- Program Additional Advanced Key
- Input the start stop unit incode and cancel the security access according to the directions on the M-MDS screen.
NOTE:
- Depending on the vehicle specification, a specified time is required until the screen changes to the incode input screen. The horn sounds two times when the incode can be input.
- "Security access permitted" is displayed on the M-MDS screen.
- Depress the clutch (MTX) or the brakes (ATX) according to the instructions on the M-MDS, and press remote transmitter 2 against the push button start while the push button start indicator light (green) is flashing. (See Procedure For Communication Between Coil Antenna And Remote Transmitter .)
- Verify that the remote transmitter 2 programming is completed on the M-MDS screen, and release the clutch (MTX) or brake (ATX) pedal.
- Are there other remote transmitters to be programmed?
|
Yes |
Change the remote transmitter and repeat Step 2. |
| No |
Switch the ignition off, then go to the next step. |
| 3 |
PERFORM IMMOBILIZER SYSTEM FUNCTION VERIFICATION
NOTE:
- Each remote transmitter is brought inside the vehicle one at a time to start the engine.
- Depress the clutch (MTX)/brake (ATX) pedal.
- After pressing remote transmitter 2 against the push button start, press the push button start to start the engine. (See Procedure For Communication Between Coil Antenna And Remote Transmitter .)
- Are there other remote transmitters to be programmed?
|
Yes |
Change the key and repeat Step 3. |
| No |
Go to the next step. |
| 4 |
VERIFY THAT REMOTE TRANSMITTER IS PROGRAMMED
Place only the programmed remote transmitter on the passenger seat and verify that the engine can be started with the programmed key. |
Go to the next step. |
| 5 |
M-MDS COMPLETION
- Wait for 5 s or more after the M-MDS is completed and Switch the ignition off.
|
Procedure is completed. |