Coupling Component Calibration Data Writing

WARNING: This page is about a different variant/trim than selected.

CAUTION:

If the characteristic value of a new coupling component is not input to the PCM or the characteristic value is input incorrectly after replacing the coupling component, it could result in the following conditions:

The system does not operate normally.
A problem with durability of the coupling component occurs.

After replacing the coupling component, read out the characteristic value of a new coupling component and write it to the PCM.
Read out the characteristic value of the coupling component from the label or mark shown in the figure.

NOTE:

The Writing the characteristic value of coupling can be performed using the M-MDS.

G13175981

Courtesy of MAZDA MOTORS CORP.

Connect the M-MDS to the DLC-2.
Perform the Writing the characteristic value of Coupling.
Perform the Reading the characteristic value of Coupling.