LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2019 >> 3 Base, 4D Hatchback, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Manual Transaxle System (Service Information)) >> Manual Transaxle Removal/Installation >> Notes

Manual Transaxle Removal/Installation: Notes

WARNING: This page is about a different variant/trim than selected.

Special Service Tool (SST) 

 
  1. Mazda SST number
  2. Global SST number
  1. 49 C017 5A0
  2. - Engine support set
G13176401Courtesy of MAZDA MOTORS CORP.
  1. 49 UN30 3050
  2. 303-050 Engine lifting bracket
G13176402Courtesy of MAZDA MOTORS CORP.
  1. 49 L017 5A0
  2. - Support hanger
G13176403Courtesy of MAZDA MOTORS CORP.
CAUTION:
  • Performing the following procedures could cause an open circuit in the front ABS wheel-speed sensor wiring harness if it is pulled by mistake. Before servicing, disconnect the front ABS wheel-speed sensor and set it aside so that the wiring harness will not be pulled by mistake.
  • Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.
scientia non olet · About LEMON Manuals