LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (Service Information) >> Up Switch Inspection >> Continuity Inspection

Continuity Inspection

NOTE:
  • The up position switch is built into the selector lever component.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION ).
  2. Remove the following parts:
    1. Selector lever knob (See AUTOMATIC TRANSMISSION SHIFT MECHANISM Removal/Installation ).
    2. Shift panel component (See SHIFT PANEL Removal/Installation ).
  3. Disconnect the selector lever component connector.
    Fig 1: Identifying Selector Lever Component Connector
    G11279177Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals C and H.
    Fig 2: Checking Continuity Between Selector Lever Component Terminals C And H
    G11279349Courtesy of MAZDA MOTORS CORP.

    Up switch specification 

    Test condition Continuity
    Selector lever is in the M position (+) side position. Continuity
    Selector lever is not in the M position (+) side position. No continuity
scientia non olet · About LEMON Manuals