LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Symptom Troubleshooting - Engine Control >> No. 26 Fuel Refill Concerns >> Diagnostic Procedure

Diagnostic Procedure

Step INSPECTION Action
1 VERIFY PCM DTC
Yes Go to the applicable DTC inspection.
(See DTC TABLE (PCM (SKYACTIV-G2.0)) ).
No Go to the next step.
2 INSPECT EVAPORATIVE SYSTEM HOSES FOR RESTRICTION
  • Inspect for restriction in the evaporative system hoses.
  • Is there any malfunction?
Yes Repair or replace the malfunctioning part according to the inspection results.
No Go to the next step.
3 DETERMINE IF MALFUNCTION CAUSE IS NON-RETURN VALVE
  • Remove the fuel-filler pipe.
  • Make sure non-return valve is installed properly.
  • Inspect the non-return valve operation.
  • Is there any malfunction?
Yes Replace the fuel tank.
(See FUEL TANK REMOVAL/INSTALLATION ).
No Except U.S.A. And CANADA:
  • Go to the next step.

    U.S.A. And CANADA:

  • Go to Step 5.
4 DETERMINE IF MALFUNCTION CAUSE IS CHECK VALVE
Yes Replace the check valve.
(See CHECK VALVE REMOVAL/INSTALLATION ).
No Inspect the following:
  • Improper use of fuel nozzle
  • Inadequate fuel filling speed

Repair or replace the malfunctioning part according to the inspection results.
5 DETERMINE IF MALFUNCTION CAUSE IS PRESSURE CONTROL VALVE
Yes Replace the pressure control valve.
No Inspect the following:
  • Improper use of fuel nozzle
  • Inadequate fuel filling speed

Repair or replace the malfunctioning part according to the inspection results.
6 Verify the test results.
  • If normal, return to the diagnostic index to service any additional symptoms. (See SYMPTOM DIAGNOSTIC INDEX ).
  • If the malfunction remains, inspect the related Service Bulletins and/or On -line Repair Information and perform repair or diagnosis.

  • If the vehicle is repaired, troubleshooting is completed.
  • If the vehicle is not repaired or additional diagnostic information is not available, reprogram the PCM if a later calibration is available. Retest.