Center Accessory Socket Inspection
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the following parts:
(1)Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .) (2)Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION .) (3)Cup holder (See CUP HOLDER REMOVAL/INSTALLATION .) (4)Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .) (5)Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .) (6)Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .) (7)Side wall (See SIDE WALL REMOVAL/INSTALLATION .) (8)Rear console (See REAR CONSOLE REMOVAL/INSTALLATION .) (9)Center accessory socket (See CENTER ACCESSORY SOCKET REMOVAL/INSTALLATION .)
- Connect the tester probe to the position shown in the figure and verify that there is continuity.
- If it cannot be verified, replace the center accessory socket. (See CENTER ACCESSORY SOCKET REMOVAL/INSTALLATION .)