Diagnostic Procedure

STARTER DOES NOT WORK (FW6A-EL, FW6AX-EL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	INSPECT WIRING HARNESS BETWEEN TCM AND PCM Switch the ignition off Disconnect the PCM connector and TCM connector Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and PCM terminal 2BD Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
1		No	Go to the next step.
2	INSPECT WIRING HARNESS BETWEEN TCM AND START STOP UNIT Disconnect the start stop unit connector Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and start stop unit terminal 1F Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
2		No	Without advanced keyless entry system: Go to step 4 With advanced keyless entry system: Go to the next step.
3	INSPECT WIRING HARNESS BETWEEN TCM AND LF CONTROL UNIT Disconnect the LF control unit connector Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between start stop unit terminal 2H and LF control unit terminal G Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
3		No	Go to the next step.
4	INSPECT IMMOBILIZER SYSTEM AND ENGINE CONTROL SYSTEM FOR MALFUNCTION Perform the symptom troubleshooting "NO. 3 WILL NOT CRANK". (See NO. 3 Will Not Crank .) Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
4		No	Symptom troubleshooting is completed.