Diagnostic Procedure

FREQUENT SHIFTING (FW6A-EL, FW6AX-EL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	INSPECT SIGNAL PARTS FOR MALFUNCTION Inspect the value at the following PCM PID using the M-MDS. (See On-board Diagnostic Test .) APP (APP sensor) Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
1		No	Go to the next step.
2	VERIFY IF MALFUNCTION CAUSE LOW-G (XY) SENSOR Is there any malfunction?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .)
2		No	Symptom troubleshooting is completed.