LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> CX-3 Touring, FWD >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transaxle Shift Mechanism >> Automatic Transaxle Shift Mechanism Removal/Installation >> Selector Cable Adjustment

Selector Cable Adjustment

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the center console tray. (See CENTER CONSOLE TRAY REMOVAL/INSTALLATION .)
  3. Remove the shift bezel. (See SHIFT BEZEL REMOVAL/INSTALLATION .)
  4. Remove the upper panel. (See UPPER PANEL REMOVAL/INSTALLATION .)
  5. Remove the selector lever knob. (See Selector Lever Removal/Installation .)
  6. Remove the shift panel. (See SHIFT PANEL REMOVAL/INSTALLATION .)
  7. Shift the selector lever to the P position.
  8. Pull out the safety lock in the direction of the arrow (1) shown in the figure, pull out the lock piece in the direction of the arrow (2) shown in the figure, and release the lock. (See Selector Cable (Selector Lever Side) Installation Note .)
    Fig 1: Pulling Out Safety Lock
    G11438231Courtesy of MAZDA MOTORS CORP.
  9. Set the manual shaft to the P position.
    Fig 2: Setting Manual Shaft To P Position
    G11438232Courtesy of MAZDA MOTORS CORP.
  10. Press in the lock piece in the direction of the arrow (1) shown in the figure, press in the safety lock in the direction of the arrow (2) shown in the figure, and lock it.
    Fig 3: Pressing Lock Piece
    G11438233Courtesy of MAZDA MOTORS CORP.
  11. Perform the procedure in the reverse order of Step  1 to  6 to install the removed part.
  12. Perform the selector lever inspection. (See SELECTOR LEVER INSPECTION .)
scientia non olet · About LEMON Manuals