LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> CX-3 Touring, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (Service Information) >> M Position Switch Inspection >> Continuity Inspection

Continuity Inspection

NOTE:
  • The M position switch is built into the selector lever component.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the selector lever knob. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
  3. Remove the following parts:
    1. Center console tray (See CENTER CONSOLE TRAY REMOVAL/INSTALLATION .)
    2. Shift bezel (See SHIFT BEZEL REMOVAL/INSTALLATION .)
    3. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION .)
    4. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    5. Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .)
    6. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
    7. CD player (See CD PLAYER REMOVAL .) (See CD PLAYER INSTALLATION .)
    8. Front console (See FRONT CONSOLE REMOVAL/INSTALLATION .)
    9. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    10. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION .)
  4. Disconnect the selector lever component connector.
    Fig 1: Selector Lever Component Connector
    G11637774Courtesy of MAZDA
  5. Verify that the continuity between selector lever component terminals E and H.
    Fig 2: Checking Continuity Between Selector Lever Component Terminals E And H
    G11637775Courtesy of MAZDA
scientia non olet · About LEMON Manuals