LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> CX-3 Touring, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 191 (Interior Trim) >> Cluster Switch Removal/Installation

Cluster Switch Removal/Installation

WARNING: This page is about a different car, the 2018 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the driver-side front scuff plate. (Se FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
  3. Remove the driver-side front side trim. (Se FRONT SIDE TRIM REMOVAL/INSTALLATION.)
  4. Partially peel back the seaming welt.
    Fig 1: Peeling Back Seaming Welt
    G12266308Courtesy of MAZDA MOTORS CORP.
  5. Remove the bolt.
    Fig 2: Removing Bolt With Torque Specifications
    G12266309Courtesy of MAZDA MOTORS CORP.
  6. Pull the driver-side lower panel in the direction of the arrow in the order of (1), (2) while detaching the hook, clips and tab.
    Fig 3: Pulling Driver-Side Lower Panel
    G12266310Courtesy of MAZDA MOTORS CORP.
  7. Set the driver-side lower panel aside.
  8. Remove the hooks in the direction of the arrow in the order of (1), (2) shown in the figure.
    Fig 4: Removing Hooks
    G12266311Courtesy of MAZDA MOTORS CORP.
  9. Disconnect the cluster switch connector.
  10. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals