Diagnostic Procedure

WARNING: This page is about a different car, the 2018 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

DTC U0336:00 (DYNAMIC STABILITY CONTROL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY SAS CONTROL MODULE DTC Using the M-MDS, perform the SAS control module DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC. )].) Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC. )].) DTC troubleshooting completed, then go to the next step.
1		No	Go to the next step.
2	VERIFY DTC TROUBLESHOOTING COMPLETED Using the M-MDS, clear the DTC from the DSC HU/Control Module. (See CLEARING DTC (Dynamic Stability Control (DSC)) .) Using the M-MDS, perform the DSC HU/Control Module DTC inspection. (See DTC INSPECTION (Dynamic Stability Control (DSC)) .) Is the same DTC present?	Yes	Repeat the inspection from Step1 If the malfunction recurs, replace the SAS control module, then go to the next step. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .)
2		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE (Dynamic Stability Control (DSC)) .)
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.