LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> CX-3 Sport, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Conventional Brake System) >> Power Brake Unit Inspection >> Using SST >> Pre-inspection preparation

Pre-inspection preparation

WARNING: This page is about a different car, the 2018 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the clips.
    Fig 1: Brake Fluid Pressure Sensor Clips
    G09075198Courtesy of MAZDA MOTORS CORP.
  2. Set the splash shield out of the way.
  3. Disconnect the brake pipe from the brake hose.
    Fig 2: Removing Brake Pipe From Brake Hose
    G09075199Courtesy of MAZDA MOTORS CORP.
  4. Remove the clip.
  5. Remove the brake hose from the bracket.
    CAUTION:
    • When removing the brake pipe, the pipe holder may detach from the body. Remove the brake pipe while pressing the pipe holder to prevent it from detaching from the body. The pipe holder cannot be reused if it detaches from the body.
  6. Detach the brake pipe from the pipe holder.
  7. Install the SST to the brake pipe as shown in the figure.
    Fig 3: Installing SST To Brake Pipe
    G11433073Courtesy of MAZDA MOTORS CORP.
  8. Bleed the brake line and the SSTs of air. Bleed the air form the SSTs using bleeder screw A.
  9. Install the pedal force gauge to the brake pedal.
  10. Connect the vacuum gauge to the vacuum line.
scientia non olet · About LEMON Manuals