Washer Motor Removal/Installation

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the set plate. (See SET PLATE REMOVAL/INSTALLATION .)
Remove the fresh-air duct installation bolts. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.5T] .) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)] .)
Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
Disconnect the washer motor connector from the washer motor.

Fig 1: Windshield Washer Hose, Washer Motor, Washer Tank And Connector
Courtesy of MAZDA MOTORS CORP.
Disconnect the windshield washer hose from the washer motor.
NOTE:
- If the washer motor is removed with washer fluid in the washer tank, the washer fluid may leak out. When removing the washer motor from the washer tank, place a container under the washer tank to collect washer fluid, and perform the procedure.
Rotate the washer motor counterclockwise/clockwise rotation repeatedly in the direction of the arrows (1) and (2) shown in the figure below, and then remove it in the direction of the arrow (3).

Fig 2: Rotating Washer Motor Counterclockwise/Clockwise
Courtesy of MAZDA MOTORS CORP.
Remove the grommet.
Install in the reverse order of removal.