LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> MX-5 Miata RF Club, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Lighting System) >> Front Side Marker Light Removal/Installation

Front Side Marker Light Removal/Installation

WARNING: This page is about a different car, the 2016 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the steering wheel to the side where the light is to be removed until it locks.
  2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  3. Partially peel back the front mudguard No. 1 and front mudguard No. 2. (See FRONT MUDGUARD REMOVAL/INSTALLATION .)
  4. Disconnect the connector.
    Fig 1: Disconnecting Connector
    G10954739Courtesy of MAZDA MOTORS CORP.
  5. Remove the screw.
  6. While pressing the front side marker light tab in the direction of arrow (1) shown in the figure, pull the front side marker light in the direction of arrow (2) and detach the front side marker light tab from the front bumper.
    Fig 2: Pressing Front Side Marker Light Tab
    G10954740Courtesy of MAZDA MOTORS CORP.
  7. Pull the front side marker light in the direction of arrow (3) shown in the figure and remove it from the front bumper.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals