LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> MX-5 Miata RF Club, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Shift Mechanism >> Not P Position Switch Inspection

Not P Position Switch Inspection

NOTE:
  • The not P position switch is built into the selector lever component.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION ).
  2. Remove the following parts:
    1. Selector lever knob (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION ).
    2. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION ).
  3. Disconnect the selector lever component connector.
    Fig 1: Identifying Selector Lever Component Connector
    G11279177Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals B and G.
    Fig 2: Checking Continuity Between Selector Lever Component Terminals B And G
    G11279402Courtesy of MAZDA MOTORS CORP.

    Not P position switch specification 

    Test condition Continuity
    Selector lever is in the P position. No continuity
    Selector lever is not in the P position. Continuity
scientia non olet · About LEMON Manuals