DTC P064A-00; Fuel Pump Control Module Error
DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P064A:00 |
Fuel pump control module error |
| DETECTION CONDITION |
- The difference between the actual fuel pressure and the target fuel pressure is 10 kPa {0.10 kgf/cm2
, 1.5 psi} or more even though the fuel pressure feedback amount on the low pressure side remains high.
Diagnostic support note
- This is a continuous monitor (other).
- The check engine light does not illuminate.
- FREEZE FRAME DATA is not available.
- Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
|
| POSSIBLE CAUSE |
- Fuel pump unit connector or terminals malfunction
- Fuel pump unit malfunction
- Fuel pump control module connector or terminals malfunction
- Short to ground in wiring harness between fuel pump unit terminal A and fuel pump control module terminal 2C
- Open circuit in wiring harness between the following terminals:
- Fuel pump unit terminal A-Fuel pump control module terminal 2C
- Fuel pump unit terminal B-Fuel pump control module terminal 2D
- Fuel pump control module malfunction
- PCM connector or terminals malfunction
- PCM malfunction
|
- If only DTC P064A:00 is stored, a DTC inspection is not necessary because this is not a vehicle malfunction. In this case, clear DCT P064A:00 stored in the PCM. (See CLEARING DTC [PCM (SKYACTIV-G 2.5T)]
.)
NOTE:
- DTC P064A:00 may be stored again even if DTC P064A:00 has been cleared.
- High fuel pressure sensor: P0087:00, P0089:00, P0192:00, P0193:00
- High pressure fuel pump: P0091:00, P0092:00
- If there is any inquiry related to drivability by a customer, verify that DTCs other than DTC P064A:00 have been stored and repair the malfunctioning location according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)]
.) (See DTC TABLE [PCM (SKYACTIV-G 2.5T)]
.)
|