Water Pump Component Installation Note

1. Tighten the bolts in the order shown in the figure.
   Fig 1: Water Pump Component Bolts Tightening Sequence

   Courtesy of MAZDA MOTORS CORP.

   Tightening torque 

   20-26 N.m {2.1-2.6 kgf.m, 15-19 ft.lbf}

2. Install the engine oil pressure sensor/engine oil temperature sensor. (See ENGINE OIL PRESSURE SENSOR/ENGINE OIL TEMPERATURE SENSOR REMOVAL/INSTALLATION .)
3. Install the wiring harness clip shown in the figure.
   Fig 2: Wiring Harness Clip And Water Pump

   Courtesy of MAZDA MOTORS CORP.
4. Tighten the bolt shown in the figure.

Fig 3: Oil Protector Bolt And Water Pump

Courtesy of MAZDA MOTORS CORP.

Tightening torque 

8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}