Selection of Procedure for Immobilizer System-Related Parts Programming
- Verify that the ROOM fuse, AT fuse, and SRS2/ESCL fuse are installed.
- Select the applicable programming procedure from the service content of the immobilizer system-related parts.
Programming Procedure Types for Immobilizer System-Related Parts Table
PROGRAMMING PROCEDURE TYPES FOR IMMOBILIZER SYSTEM-RELATED PARTSNo. Service Programming procedure 1 When programming additional remote transmitter (1) (See No. 1 Additional Remote Transmitter Programming Procedure (Using the M-MDS) .) 2 When PCM is replaced (See No. 2 Programming Procedure After PCM Replacement .) 3 - When start stop unit is replaced
- When PCM and start stop unit are replaced simultaneously
(See No. 3 Programming Procedure When Start Stop Unit Is Replaced Or When Start Stop Unit And Pcm Are Replaced Simultaneously .) 4 - When remote transmitter is replaced
- When remote transmitter is lost
(See No. 4 Procedure For Remote Transmitter Clearing And Newly Programming .) (1) Have a remote transmitter that can start the engine. M-MDS Connecting Procedure
NOTE:- Do not place the M-MDS in the vehicle while programming the immobilizer system.
- Fully lower the door glass.
- Connect the M-MDS to the DLC-2.
- Place the M-MDS outside the vehicle.CAUTION:
- Cover the vehicle body with a rag so as not to damage the vehicle body with the cable.