Engine Oil Replacement

Replacement Part

Gasket

Quantity: 1

Location of use: Oil pan drain plug

Oil and Chemical Type

Engine oil

Type: Recommended oil

WARNING:

Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.

CAUTION:

If engine oil is spilled on the exhaust system, wipe it off completely. If you fail to wipe the spilled engine oil, it will produce fumes because of the heat.

Position the vehicle on level ground.
Remove the oil filler cap.
Remove the service hole cover (installed to front under cover No. 2) used to drain the engine oil.

Fig 1: Removing Service Hole Cover With Screw
Courtesy of MAZDA MOTORS CORP.
Remove the oil pan drain plug.
Drain the engine oil into a container.
Install the oil pan drain plug with a new gasket.
Oil pan drain plug tightening torque

30-41 N.m {3.1-4.1 kgf.m, 23-30 ft.lbf}

Refill with the following type and amount of engine oil.

ENGINE OIL GRADE SPECIFICATION

Item	U.S.A. and CANADA	Except U.S.A. and CANADA
Engine oil grade	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
Engine oil grade	Courtesy of MAZDA MOTORS CORP.	API SM or ILSAC
Engine oil viscosity	0W-20	5W-30 (If SAE 5W-30 engine oil is not available, use SAE 5W-20 engine oil.)

Engine oil capacity [SKYACTIV-G 2.0] (approx. quantity)

Oil replacement: 4.0 L {4.2 US qt, 3.5 lmp qt}

Oil and oil filter replacement: 4.2 L {4.4 US qt, 3.7 lmp qt}

Total (dry engine, without oil cooler): 4.9 L {5.2 US qt, 4.3 lmp qt}

Total (dry engine, with oil cooler): 5.0 L {5.3 US qt, 4.4 lmp qt}

Engine oil capacity [SKYACTIV-G 2.5] (approx. quantity)

Oil replacement: 4.3 L {4.5 US qt, 3.8 lmp qt}

Oil and oil filter replacement: 4.5 L {4.8 US qt, 4.0 lmp qt}

Total (dry engine, without oil cooler): 5.4 L {5.7 US qt, 4.8 Imp qt}

Total (dry engine, with oil cooler): 5.5 L {5.8 US qt, 4.8 Imp qt}

Install the oil filler cap.
Start the engine and confirm that there is no oil leakage.
- If there is oil leakage, repair or replace the applicable part.
Inspect the oil level. (See ENGINE OIL LEVEL INSPECTION .)
Install the service hole cover.
If the engine oil maintenance monitor function is set on, reset the engine oil data. (See ENGINE OIL DATA RESET .)