LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Air Bag System (Service Information) - Two-Step Deployment Control System) >> Crash Zone Sensor Removal/Installation [Two-Step Deployment Control System] >> Connector Disconnect Note

Connector Disconnect Note

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press the area (1) indicated by the arrow and slide it as shown in the figure (2).
    Fig 1: Disconnecting Crash Zone Sensor Connector
    G10937912Courtesy of MAZDA MOTORS CORP.
  2. Lift up the location shown in the figure using a tape-wrapped flathead screwdriver (3) and disconnect the connector (4).
scientia non olet · About LEMON Manuals