LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> 6 Touring, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Air Bag System (Service Information) - Two-Step Deployment Control System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures [Two-Step Deployment Control System] >> Deployment Procedure for Inside of Vehicle >> Pre-tensioner Seat Belt

Pre-tensioner Seat Belt

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    3. B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
  2. Using a flathead screwdriver, lift the locking device carefully, however do not remove it.
    Fig 1: Lifting Locking Device Using Flathead Screwdriver
    G11428361Courtesy of MAZDA MOTORS CORP.
  3. Disconnect the pre-tensioner seat belt connector.
  4. Connect the SST (Adapter harness) as shown in the figure.
  5. Connect the SST (Deployment tool) to the SST (Adapter harness).
    Fig 2: Connecting SST (Deployment Tool) And SST (Adapter Harness)
    G09787172Courtesy of MAZDA MOTORS CORP.
  6. Connect the SST (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.
  7. Verify that the red lamp on the SST (Deployment tool) is illuminated.
  8. Verify that all persons are standing at least 6 m {20 ft} away from the vehicle.
  9. Press the activation switch on the SST (Deployment tool) to operate (deploy) the pre-tensioner seat belt.
    Fig 3: SST Deployment Tool Activation Switch
    G11428349Courtesy of MAZDA MOTORS CORP.
    WARNING:
    • The pre-tensioner seat belt is very hot immediately after it is operated (deployed). You can be burned. Do not touch the pre-tensioner seat belt for at least 15 min after deployment.
  10. Disconnect the SST (Deployment tool) from the SST (Adapter harness).
scientia non olet · About LEMON Manuals