DTC B1008 62: Windshield Wiper Lo Switch Signal Mismatch: Notes
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC B1008:62 (FRONT BODY CONTROL MODULE) DETECTION CONDITION AND POSSIBLE CAUSES
| Description |
Windshield wiper LO switch signal mismatch |
| Detection condition |
- The condition in which the CAN and module signals are compared and no match is detected between the signals for 5 s or more
with the ignition switched ON (engine off or on).
|
| Fail-safe function |
Not applicable |
| Possible cause |
- Start stop unit malfunction
- Windshield wiper switch malfunction
- Short to ground in wiring harness between start stop unit terminal 1V and front body control module (FBCM) terminal 2Y
- Short to power supply in wiring harness between start stop unit terminal 1V and front body control module (FBCM) terminal 2Y
- Open circuit in wiring harness between start stop unit terminal 1V and front body control module (FBCM) terminal 2Y
- Front body control module (FBCM) malfunction
|
 Courtesy of MAZDA MOTORS CORP.
|