DTC U2300-54; Configuration Data Not Received From Instrument Cluster: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE
| Description |
Configuration data not received from instrument cluster |
| Detection condition |
- Blind spot monitoring (BSM) control module cannot receive the configuration signal it is supposed to receive.
|
| Fail-safe |
- Blind spot monitoring (BSM) system is stopped.
|
| Possible cause |
NOTE:
- To correctly write the configuration data sent from the instrument cluster to the blind spot monitoring (BSM) control module to the blind spot monitoring (BSM) control module, 30 s or more need to have elapsed since the ignition was switched ON (engine off or on).
- DTCs are stored in the instrument cluster.
- Instrument cluster configuration not implemented
- Instrument cluster internal memory malfunction
- Blind spot monitoring (BSM) control module malfunction
|
| System wiring diagram |
Not applicable |