LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> 6 Sport, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Air Bag System (Service Information) - Two-Step Deployment Control System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures [Two-Step Deployment Control System] >> Deployment Procedure for Outside of Vehicle >> Notes

Deployment Procedure for Outside of Vehicle: Notes

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the SST (Deployment tool). (See INSPECTION OF SST (DEPLOYMENT TOOL) [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)
  2. Switch the ignition off.
  3. Disconnect the negative battery cable and wait for 1 min or more. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  4. Follow the procedure below for operating (deploying) the applicable air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt.
    NOTE:
    • The connector part of the air bag module and the SST (adapter wiring harness) burns out from the high heat when the inflator is operated (deployed).
scientia non olet · About LEMON Manuals