LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> 6 Sport, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Hood Release Cable Removal/Installation

Hood Release Cable Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Set plate (See SET PLATE REMOVAL/INSTALLATION .)
    2. Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION .)
    3. Front combination light (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION .)
    4. Shroud upper member (See SHROUD UPPER MEMBER REMOVAL/INSTALLATION .)
    5. Front mudguard (Driver's side) (See MUDGUARD REMOVAL/INSTALLATION .)
    6. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
  3. Disconnect the hood release cable from the hood latch.
  4. Remove the hood release cable from clip.
    Fig 1: Locating Hood Release Cable
    G09787727Courtesy of MAZDA MOTORS CORP.
  5. Press the grommet into the cabin side.
  6. Remove the hood release cable from the cabin side.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals