DTC Inspection SAS Control Module (Two-Step Deployment Control System): Notes

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If the self-test is implemented, the seat weight sensor calibration is performed. Perform the DTC inspection in accordance with the following conditions:

Do not place objects on the front seat (passenger side)
Do not touch the front seat (passenger side)
Fix the slide position of the front seat (passenger side) to the maximum rearward position.
Fix the recliner position of the front seat (passenger side) to the maximum forward position.
Set cabin vehicle temperature range between the-10 to 40 °C {14 to 104 °F}
Other than the above conditions, a "Japan only" command is also displayed, however, do not select the command because it is for use in Japan only.