LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> 3 Sport, 4D Hatchback, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Electric Power Steering System) >> Steering Wheel And Column Removal/Installation >> Steering Column Component Removal Note

Steering Column Component Removal Note

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Always lock the adjusting lever to prevent damage to the steering column. In addition, do not unlock the adjusting lever until after the steering column installation is completed.
  • If the steering column is removed, remove it according to the procedure to prevent damage to intermediate shaft that could result if the steering column is removed in the incorrect order.
  1. Lock the adjusting lever.
  2. Place alignment marks on the steering gear (pinion) and the intermediate shaft as shown in the figure.
  3. Remove the bolt, disconnect the intermediate shaft from the steering gear (pinion shaft).
  4. Remove the nut, and then remove the steering column component from the dashboard member.
    Fig 1: Identifying Alignment Marks On Steering Gear (Pinion) And Intermediate Shaft
    G09075669Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals