Washer Fluid-Level Sensor Inspection

Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
Remove the set plate. (See SET PLATE REMOVAL/INSTALLATION .)
Remove the front bumper. (See FRONT BUMPER REMOVAL .) (See FRONT BUMPER INSTALLATION .)
Disconnect the connector. (See WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION .)
Verify that the continuity between the washer fluid-level sensor terminals is as indicated in the table.

Fig 1: Washer Fluid-Level Sensor Continuity Reference Chart
Courtesy of MAZDA MOTORS CORP.

Fig 2: Locating Washer Fluid-Level Sensor Terminal
Courtesy of MAZDA MOTORS CORP.
- If not as indicated in the table, replace the washer fluid-level sensor. (See WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION .)