Reading DTCs Procedure

Connect the M-MDS to the DLC-2.
After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
1. Select "Self Test".
2. Select "Modules".
3. Select "TCM".
NOTE:
- Snapshot data appears at the top of the help screen when the displayed DTC is selected.
  Snapshot data
- The data for all DTCs currently detected is stored.
  Recorded DTC timing
  - For DTCs with one drive cycle, data is recorded during the malfunction determination period.
  - For DTCs with two drive cycles, data is recorded during non-determination (1st diagnosis) periods.
Then, select the "Retrieve CMDTCs" and perform procedures according to the directions on the M-MDS screen.
Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
After completion of repairs, clear all DTCs stored in the TCM. (See SNAPSHOT DATA ITEM TABLE .)