Bluetooth® UNIT REMOVAL/INSTALLATION
WARNING: This page is about a different car, the 2014 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The audio unit communicates with the Bluetooth® unit and records the presence/non-presence of the Bluetooth® unit when the ignition is switched to ACC or ON (engine off or on) after connecting the negative battery cable.
- If the commander switch is installed with the negative battery cable connected when the audio unit records that there is no Bluetooth® unit, the Bluetooth® unit does not operate.
- For the Bluetooth® unit installation/removal, disconnect the negative battery cable, switch the ignition to ACC or ON (engine off or on) after the servicing is completed, and the audio unit records the presence/non-presence of the Bluetooth® unit.
NOTE:
- The Bluetooth® pairing information recorded in the Bluetooth® unit cannot be written to a new Bluetooth® unit. Therefore, the Bluetooth® pairing formation will be eliminated if the Bluetooth® unit is replaced. Before replacing the Bluetooth® unit, explain to the customer that the Bluetooth® pairing resetting is required.
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- Remove the following parts:
- Front scuff plate (RH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
- Front side trim (RH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
- Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
- Remove the clip.
- Remove the bolts.
- Disconnect the connector.
- Remove the wiring harness clip.
- Remove the Bluetooth® unit component.
- Remove the screws.
- Remove the Bluetooth® unit.
- Install in the reverse order of removal.