Keyless Receiver Inspection: 5HB

Remove the following parts:
1. Trunk covering (Refer to TRUNK COVERING REMOVAL/INSTALLATION .)
2. Trunk board (Refer to TRUNK BOARD REMOVAL/INSTALLATION .)
3. Trunk end trim (Refer to TRUNK END TRIM REMOVAL/INSTALLATION .)
4. Rear seat cushion (Refer to REAR SEAT CUSHION REMOVAL/INSTALLATION .)
5. Rear scuff plate (RH) (Refer to REAR SCUFF PLATE REMOVAL/INSTALLATION .)
6. Tire house trim (RH) (Refer to TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
7. Rear package tray (Refer to REAR PACKAGE TRAY REMOVAL/INSTALLATION .)
8. Trunk side upper trim (RH) (Refer to TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION .)
9. C-pillar trim (RH) (Refer to C-PILLAR TRIM REMOVAL/INSTALLATION .)
Remove the keyless receiver with the connector still connected. (Refer to KEYLESS RECEIVER REMOVAL/INSTALLATION .)
Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
  - If the system does not operate normally even though the parts under Inspection Item(s) and related wiring harnesses do not have any malfunction, replace the keyless receiver.