Keyless Receiver Inspection: 4SD

Remove the following parts:
1. Rear scuff plate (RH) (Refer to REAR SCUFF PLATE REMOVAL/INSTALLATION .)
2. Rear seat cushion (Refer to REAR SEAT CUSHION REMOVAL/INSTALLATION .)
3. Tire house trim (RH) (Refer to TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
4. C-pillar trim (RH) (Refer to C-PILLAR TRIM REMOVAL/INSTALLATION .)
Remove the keyless receiver with the connector still connected. (Refer to KEYLESS RECEIVER REMOVAL/INSTALLATION .)
Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
  - If the system does not operate normally even though the parts under Inspection Item(s) and related wiring harnesses do not have any malfunction, replace the keyless receiver.