LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2015 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transmission Shift Mechanism >> Selector Lever Removal/Installation >> Notes

Selector Lever Removal/Installation: Notes

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Remove the following parts.
    1. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    2. Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
    3. Driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION .)
    4. Steering shaft (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
    5. Audio unit (See CENTER PANEL UNIT REMOVAL/INSTALLATION .)
    6. SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
    7. Tunnel member component
    8. Middle pipe (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF] .)
    9. Insulator (See TRANSMISSION RANGE (TR) SWITCH REMOVAL/INSTALLATION [SJ6A-EL] .)
  4. Shift the selector lever to the P position.
  5. Remove in the order indicated in the chart.
  6. Install in the reverse order of removal.
  7. After installation, perform the shift lock inspection and key interlock inspection. (See SHIFT LOCK INSPECTION .) (See KEY INTERLOCK INSPECTION .)
    Fig 1: Selector Lever Components With Torque Specifications
    G06150492Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals