LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2015 >> CX-5 Touring, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Conventional Brake System) >> Power Brake Unit Inspection >> Using SST >> Pre-inspection preparation

Pre-inspection preparation

WARNING: This page is about a different car, the 2013 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the clips.
  2. Set the splash shield out of the way.
    Fig 1: Identifying Clips
    G09075198
  3. Disconnect the brake pipe from the brake hose.
  4. Remove the clip.
  5. Remove the brake hose from the bracket.
  6. Detach the brake pipe from the pipe holder.
    Fig 2: Identifying Pipe Holder, Brake Hose And Clip
    G09075199
  7. Install the SST  to the brake pipe as shown in the figure.
  8. Bleed the brake line and the SSTs  of air. Bleed the air form the SSTs  using bleeder screw A.
  9. Install the pedal force gauge to the brake pedal.
  10. Connect the vacuum gauge to the vacuum line.
    Fig 3: Installing SST To Brake Pipe
    G09075200
scientia non olet · About LEMON Manuals