LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2015 >> CX-5 Touring, FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Front Seat Adjuster Unit Removal/Installation >> Passenger-side

Front Seat Adjuster Unit Removal/Installation: Passenger-side

  1. Switch the ignition off (LOCK).
  2. Disconnect the negative battery cable and waif for 1 min  . (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  3. Remove the following parts:
    1. Front seat (See FRONT SEAT REMOVAL/INSTALLATION .)
    2. Front seat side cover (See FRONT SEAT SIDE COVER REMOVAL/INSTALLATION .)
    3. Front buckle (See FRONT BUCKLE REMOVAL/INSTALLATION .)
    4. Seat weight sensor control module (See SEAT WEIGHT SENSOR CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)
  4. Slide hook A in the order of arrows (1), (2), (3) shown in the figure and set the front seat cushion trim aside.
  5. Disconnect the seat weight sensor control module connector.
    Fig 1: Disconnecting Seat Weight Sensor Control Module Hook
    G09076777Courtesy of MAZDA MOTORS CORP.
    Fig 2: Seat Weight Sensor Control Module Connector End View
    G09076834Courtesy of MAZDA MOTORS CORP.
  6. Using a flathead screwdriver, disconnect the connector in the direction of the arrow (5) while releasing tab B in the direction of the arrow (4) shown in the figure.
  7. Remove bolts A.
    Fig 3: Seat Weight Sensor Control Module Bolts With Torque Specifications
    G09076835Courtesy of MAZDA MOTORS CORP.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals