Common Specs & Procedures Index
CX-5 COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | HVAC TECHNICAL DATA | ||
| Torque | See Torque Specifications in appropriate graphics under CONTROL SYSTEM [HVAC SYSTEM - FULL AUTO AIR CONDITIONER SYSTEM) or CONTROL SYSTEM [HVAC SYSTEM - MANUAL AIR CONDITIONER SYSTEM) | ||
| Axle Nut/Hub Nut | |||
| Front | Step 1
74-110 Ft. Lbs. (100-150 N.m) Step 2 Loosen 180 Degrees Step 3 175-202 Ft. Lbs. (236-274 N.m) |
||
| Rear | Step 1
74-110 Ft. Lbs. (100-150 N.m) Step 2 Loosen 180 Degrees Step 3 175-202 Ft. Lbs. (236-274 N.m) |
||
| Battery | BATTERY INSPECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Brakes | |||
| Bleeding Sequence | See - BRAKE FLUID AIR BLEEDING . | ||
| Disc Brakes | |||
| Service Specifications | BRAKES TECHNICAL DATA | ||
| Torque | See Torque Specifications in text and appropriate graphics under CONVENTIONAL BRAKE SYSTEM | ||
| Charging | |||
| Generator | GENERATOR INSPECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Torque | See Torque Specifications in text and appropriate graphics under CHARGING SYSTEM | ||
| Drive Belts | |||
| Adjustment | Engine uses Self-Adjusting Serpentine Drive Belt | ||
| Drive Belt Routing | NA | ||
| Engine Cooling | |||
| General Service Specifications | ENGINE TECHNICAL DATA [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Radiator Cap Pressure | 16-21 psi | ||
| Thermostat R & I | THERMOSTAT REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Water Pump R & I | WATER PUMP REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Engine Mechanical | |||
| SKYACTIV-G 2.0 | |||
| Compression | COMPRESSION INSPECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Oil Pressure | Lo: 110-175 kPa {1.13-1.78 kgf/2
, 16.0-25.3 psi} [1, 500 RPM] Hi: 300-430 kPa {3.06-4.38 kgf/2 , 43.6-62.3 psi} [4, 500 RPM] |
||
| Overhaul | ENGINE TECHNICAL DATA [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Torque | See Torque Specifications in text and appropriate graphics under ENGINE MECHANICAL [SERVICE, REMOVAL AND INSTALLATION - SKYACTIVE-G 2.0L/SKYACTIVE-G 2.5L] , ENGINE MECHANICAL - OVERHAUL - SKYACTIV-G- 2.0L or ENGINE MECHANICAL - OVERHAUL - SKYACTIV-G-2.5 . | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | M/T
Step 1 = 34-39 Ft. Lbs. (45-54 N.m) Step 2 = 57-61 Ft. Lbs.(74-84 N.m) Step 3 = 80-85 Ft. Lbs. (108-116 N.m) A/T = 80-85 Ft. Lbs. (108-116 N.m) |
||
| Fuel System | |||
| Pressure Specification | SKYACTIVE-G2.0L 405-485 kPa {4.13-4.94 kgf/cm2 , 58.8-70.3 psi} | ||
| Fuel Pressure Test Procedure | SKYACTIVE-G2.0L FUEL LINE PRESSURE INSPECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] |
||
| Fuel Filter Location | Hi And Low Pressure Fuel Filters Are Attached To Fuel Pump Unit In Fuel Tank. | ||
| Fuel Filter R & I | SKYACTIVE-G2.0L FUEL FILTER (HIGH-PRESSURE) REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Ignition | |||
| Firing Order & Cylinder Identification | See ENGINE TECHNICAL DATA [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Ignition Wires (Resistance) | NA Coil On Plug | ||
| Ignition Wires (Routing) | NA Coil On Plug | ||
| Spark Plug | |||
| PE01-18110, PE02-18110 | |||
| Gap | Standard: 0.75-1.10 mm {0.030-0.043 in} New spark plug (reference): 0.75-0.85 mm {0.030-0.033 in} |
||
| Torque | 15-20 N.m {1.6-2.0 kgf.m, 12-14 ft.lbf} | ||
| Starting | |||
| Starter | STARTER INSPECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] | ||
| Torque | 29-38 Ft. Lbs. (38-52 N.m) | ||
| Wheel Alignment | |||
| Adjustment Specifications | FRONT WHEEL ALIGNMENT or REAR WHEEL ALIGNMENT | ||
| Torque | See Torque Specifications in text under FRONT WHEEL ALIGNMENT or REAR WHEEL ALIGNMENT | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 108-147 N.m {12-14 kgf.m, 80-108ft.lbf} | ||