Washer Fluid-Level Sensor Removal/Installation
WARNING: This page is about a different car, the 2013 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
- Set the front over fender aside. (See FRONT OVER FENDER REMOVAL/INSTALLATION ).
- Set the mudguard (RH) aside. (See MUDGUARD REMOVAL/INSTALLATION ).
- Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION ).
- Disconnect the washer fluid-level sensor connector.
- Remove the washer fluid-level sensor.NOTE:
- If the washer fluid-level sensor is removed with washer fluid in the washer tank, the washer fluid may leak out. When removing the washer fluid-level sensor from the washer tank, place a container under the washer tank to collect washer fluid, and perform the procedure.
- Remove the grommet.
- Install in the reverse order of removal.