LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2015 >> CX-5 Touring, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> On-Board Diagnostics - Laser Sensor >> On-Board Diagnosis >> Snapshot Data Table

Snapshot Data Table

NOTE:
  • Refer to PID monitor table for confirm the laser sensor operation status while the laser sensor does not store the DTC. (See PID/DATA MONITOR TABLE .)
  • Snapshot data items are not displayed, according to detected DTC.
SNAPSHOT DATA ITEM DESCRIPTION

-: Not applicable
Snapshot data item Unit Data contents Data read/use method Corresponding data monitor items
DSC_R_BRK OK/Error DSC response against brake request from SCBS module - -
DSC_R_BRK_C OK/Error DSC response against brake assist threshold change from SCBS module - -
DSC_R_BRK_NOREQ OK/Error DSC response while no request from SCBS module - -
DSC_R_PREC H OK/Error DSC response against pre-charge request from SCBS module - -
DSC_SYSTEM OK/Error DSC system condition - -
ECU_IN_TEMP °C ECU internal temperature - -
PCM_R_NOREQ OK/Error PCM response while no request from SCBS module - -
PCM_R_REQ OK/Error PCM response against request from SCBS module - -
PCM_SYSTEM OK/Error PCM system condition - -
TOTAL_DIST km/miles Accumulated total traveled distance from completion of vehicle until laser sensor detects DTC (Odometer value in instrument cluster) The distance traveled when the laser sensor detected a DTC can be calculated by performing the following procedure.
  1. Verify the odometer value in the instrument cluster.
  2. Verify the snap shot data item TOTAL_DIST.
  3. Subtract 2 from 1.
 -
TOTAL_TIME hh:mm:ss(1) Accumulated total elapsed time since vehicle completion until laser sensor detects a DTC
NOTE:
  • When the ROOM fuse is removed, and the ignition is switched off, the time is not included in the elapsed time.
 The elapsed time when the laser sensor detected a DTC can be calculated by performing the following procedure.
  1. Verify the PID item TOTAL_TIME of the instrument cluster.
  2. Verify the snap shot data item TOTAL_TIME.
  3. Subtract 2 from 1.
 TOTAL_TIME(2)
VPWR V Power supply - -
VSPD KPH, MPH Vehicle speed - VSPD
(1) The seconds may be indicated after the decimal point.
(2) Instrument cluster PID (See PID/DATA MONITOR TABLE [INSTRUMENT CLUSTER] .)
scientia non olet · About LEMON Manuals