Condenser Removal/Installation: Notes

Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
Remove the following parts:
1. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
2. Trunk end trim (LH) (See TRUNK END TRIM REMOVAL/INSTALLATION .)
3. Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
4. Trunk side trim (LH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
5. D-pillar trim (LH) (See D-PILLAR TRIM REMOVAL/INSTALLATION .)
Disconnect the connector.

Fig 1: D-Pillar LH, Condenser, Connector And Mounting Bolt With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Remove the bolts.
Remove the condenser.
Install in the reverse order of removal. (See CONDENSER INSTALLATION NOTE .)