LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2015 >> 3 SV, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Entertainment System) >> Rear Speaker Inspection

Rear Speaker Inspection

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5] .)
  2. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    3. Rear side seat back (See REAR SIDE SEAT BACK REMOVAL/INSTALLATION .)
    4. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    5. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    6. High-mount brake light (See HIGH-MOUNT BRAKE LIGHT REMOVAL/INSTALLATION .)
    7. Rear package trim (See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
    8. Rear speaker (See REAR SPEAKER REMOVAL/INSTALLATION .)
  3. Verify that the resistance between the front center speaker terminals is as indicated in the table.
    • If not as indicated in the table, replace the rear speaker.
      Fig 1: Checking Resistance Between Front Center Speaker Terminals
      G09788359Courtesy of MAZDA MOTORS CORP.
      Fig 2: Rear Speaker - Circuit Diagram
      G09077668Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals