Seat Weight Sensor Inspection [Two-Step Deployment Control System]
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS.
- Removal of the passenger-side seat
- Loosening and retightening of passenger's seat fixing bolts
- Or, the vehicle was involved in a collision
- If any of the following work is performed, perform the seat weight sensor calibration using the M-MDS. (See
SEAT WEIGHT SENSOR CALIBRATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)
- Replacement with a new seat weight sensor
- Replacement with a new seat weight sensor control module
- Replacement with new passenger-side seat parts
- Disassembly of the passenger-side seat
- Connect the M-MDS to the DLC-2.
- Verify that SAS control module DTC B00A0:28 is detected using the M-MDS.
- If DTC B00A0:28 is detected, perform the on-board diagnostic system procedure. (See DTC B00A0:28 [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)